Burningman 2022:


Waking Dreams

Arising Phoenix

Building a Phoenix

Home
Overview Pages:
the Plan part 1: Making Plans | the Plan part 2: Cross Sections | the Plan part 3: Longitudinals the Plan part 4: Wings, Tail & Legs the Plan part 5: Base

wizzard's chronological Photos:
Picking up in Paradise 1 | Picking up in Paradise 2 | Treasures in Campbell
Building Starts | Building 2 | Building 3 | Building 4 | Building 5 | Building 6 | xxx | xxx | xxx

Gwen's chronological Photos:
Paradise 1 | Paradise 2 | Paradise 3 | Build 1 | Build 2 | Build 3 | Build 4 | Build 5 | Build 6 | xxx

Building 3

Building and mounting the rings continues.

previous | next

[orig. huge image]
2019/12/16

[orig. huge image]

[orig. huge image]

[orig. huge image]

[orig. huge image]

My hard-to-photograph model of the Phoenix

[orig. huge image]

[orig. huge image]

[orig. huge image]

[orig. huge image]

About to weld ring #7 at the base of the neck. By this point I'd decided to have the head looking downward rather than toward the sky.

[orig. huge image]
2019/12/17

I welded on a short piece of square tubing at the top of the main support to act as a socket for the neck that will now over hang too far to be towed on a trailer; it will need to be made to be removeable. I used a cutoff piece of the main and neck tubing to reserve the space needed to fit the ring over both.

[orig. huge image]

[orig. huge image]

Took a pause for a day to can some batches of Persimmon Jams. Most of them also have hot peppers in the jams like Habanero and Ghost peppers.

[orig. huge image]
2019/12/18

[orig. huge image]

The finished ring #7.

[orig. huge image]

By this point I realized I'd need an eigth ring because of the downward curve.

[orig. huge image]
2019/12/19

I just kinda like this fuzzy image

[orig. huge image]

[orig. huge image]

[orig. huge image]

Ring 7 seen from above with both square pipes. It is being redied for welding in place.

[orig. huge image]

[orig. huge image]

[orig. huge image]

I'd been working on the head for a little while but forgot to take photos till now.

[orig. huge image]
2019/12/21

The main beak is made from a post hole digger (shovel) that I cut with a hack saw and bent to shape. The red clay is the shape I want the beak to be. I'm thinking of using some sockets cut in half to make the shape I'm looking for.

[orig. huge image]

[orig. huge image]

[orig. huge image]

[orig. huge image]

[orig. huge image]

Building the spine of the neck. The 3 pipe wrenches at the top are connected to each other and the square pipe that slots into the neck hole. Note that those 3 are not welded to the rest of the body.

[orig. huge image]
2019/12/22

[orig. huge image]

Temporarily placing the head in place to check the pose. The Aluminum foil is in place to protect the ceramic cups I originally wanted to use as eyes from sparks and flying molten welding rod.

[orig. huge image]

[orig. huge image]
2019/12/23

[orig. huge image]

Ring #8 that will be halfway between the body and the head.

[orig. huge image]
2019/12/26

[orig. huge image]

[orig. huge image]

[orig. huge image]

Some head shots of my Birdie

[orig. huge image]

[orig. huge image]

[orig. huge image]